[davekoenig]

Hi

I'm having two problems

1) I only want to show a couple datasets up in the legend. Is this possible?

2) On a MSLine graph I have the x-axis as time in seconds. I'm essentially creating a waterfall chart by having multiple series and having much of the line with alpha = 0 so it's not visibile. Each series start and end point (where the alpha isn't 0) must be a category. Say I have two lines with their end points being at [0,25] and [15,63]. I'd thus have to add categories of 0,15,25,63...which isn't a problem, except they are equally spaced on the x-axis. It would make the graph much clearer if the gap between 25 and 63 was proportional to the actual gap. Is there a way I can do this?

Any help is muchly appreciated.
Dave

[Angshu]

Hi,

Welcome to FusionCharts Forum!

Could you please send us a screenshot of your requirement?

Awaiting for your reply.

[davekoenig]

Hi Angie.

In the attached screen shot, you'll notice the xaxis isn't to scale for it's values. For the legend I'd only like to have say one red dot with the title "TalkToSourceControl" with say the idea if they hover over the specific line they get the extra info "CheckServerStatus" or whatever..


Cheers

Dave

Angie, on 16 March 2011 - 05:15 AM, said:

Hi,

Welcome to FusionCharts Forum!

Could you please send us a screenshot of your requirement?

Awaiting for your reply.

[Angshu]

Hi,

Welcome to FusionCharts Forum!

I am afraid, FusionCharts does not support the feature you are looking for, at this time.

You can add custom text to each of the bars or lines using the <toolText> attribute.

Hope this helps.