Chart properties in FC 3.4 & Documentation

[kaipahl]

Hi,

 

two remarks concerning the FC 3.4-Upgrade and the new documentation.

 

* Inside the documentation of Multi-series 2D, in the "Divisional Lines and Grids" section, the property "numvdivlines" is missing. It was there in the FC v3.3.1SR1 doc and it still works under v3.4. 

 

* The property "showVDivLines" has changed in FC 3.4 for Multi-series 2D. If showVDivLines=1 then *each* value gets a vLine, ignoring the values of the "labelstep" and "numvdivlines" properties. Is it a bug or is this change in behavior not documented?

[Swarnam]

Hi,

 

Welcome to FusionCharts Forum Post.

* Inside the documentation of Multi-series 2D, in the "Divisional Lines and Grids" section, the property "numvdivlines" is missing. It was there in the FC v3.3.1SR1 doc and it still works under v3.4. 

>>Vertical divisional lines are supported in a line/area chart. This attribute is present in Multi Series Line/Area chart docs.

* The property "showVDivLines" has changed in FC 3.4 for Multi-series 2D. If showVDivLines=1 then *each* value gets a vLine, ignoring the values of the "labelstep" and "numvdivlines" properties. Is it a bug or is this change in behavior not documented?

>> "showVDivLines" is supported only by ZoomLine charts till FC v3.3.1-SR3. However, the same functionality has been extended to Line/Area chart in v3.4 and documentation is "InProgress". If you would like to show divisional lines less than category count, please specify "numVDivLines" attribute.

 

Hope this helps.