steveddei Report post Posted October 1, 2009 Hello, I have used a % value for a few of my charts, which correctly scales the width of the chart to width of the table/div, however I noticed when I apply a % value to the Doughnut3D chart, the chart does not display. Here is my code: $FC3 = new FusionCharts("MSBar3D", "450", "550"); $FC4 = new FusionCharts("MSBar3D", "100%", "550"); $FC5 = new FusionCharts("Doughnut3D", "450", "300"); $FC6 = new FusionCharts("Doughnut3D", "100%", "300"); $FC3, $FC4 and $FC5 displays correctly, $FC6 does not display at all. If I set it to a whole number (pixels) it displays. Is this a bug for this chart? I havent tried all charts, but this is the first one i came across that could not take a % value. Thanks. Share this post Link to post Share on other sites
Guest Madhumita Report post Posted October 6, 2009 Hi, Can you please send us your code. So far we have not been able to recreate the same issue. The Doughnut chart takes percentage values. Your code will help us analyse why the issue is occurring. I apologize for the inconvenience caused. Share this post Link to post Share on other sites
Andrew S. Report post Posted October 6, 2009 Hi, I've faced with similar problem recently. Do you use IE or FF browser? Share this post Link to post Share on other sites
Guest Rajroop Report post Posted October 6, 2009 Hello Andrew, We have tested on both the browsers cited by you. Could you please specify/elaborate a bit more on the issue that you are facing? Kindly add your code to your post for our testing purposes, if possible. Looking forward to your reply. Share this post Link to post Share on other sites