sverma Report post Posted December 20, 2009 Hi I do have a requirement where y axis values should display same no. of decimal places. I can see that forceDecimal = 1 just works for the data plot values but not for the y axis values. This issue was reported in 2007 as well. I hope you guys have fixed it by now. I want my y axis to have values like 0.00 0.25 0.50 1.00 ... Regards Saurabh Share this post Link to post Share on other sites
Guest Madhumita Report post Posted December 21, 2009 Hello, Welcome to FusionCharts forum. The attribute yAxisValueDecimals is used to set the decimal precision for the y-axis values. However, as of now, the forceDecimals attribute does not work upon the y-axis values. If a number on the yaxis is already rounded then decimals cannot be forced on the value on y-axis. Your suggestions are very important to us. We have made a note of the same. Share this post Link to post Share on other sites
sverma Report post Posted December 21, 2009 Thanks for the reply, this issue is critical to us as part of release. We have licensed version of FusionCharts. It will be great if this issue is addressed quickly. The thing is we are not displaying the value of data plot i.e. over the bar (Column2D). So only y axis labels are visible as source of information hence consistency in decimal precision over y axis labels is critical to us. Regards Saurabh Share this post Link to post Share on other sites
Guest Madhumita Report post Posted December 21, 2009 Hello, As a workaround, you can use trendlines and displayValue attribute of the line element to display such values. If you can provide us with your XML we can do the same. Looking forward to your reply. Share this post Link to post Share on other sites
[email protected] Report post Posted January 7, 2010 hi, Fusion chart is amazing, Thank u for ur Fusion Chart V3 See i want to change a Y-axis value. It should start from 10,20,30... Yours Satheeshkumar Share this post Link to post Share on other sites
Guest Madhumita Report post Posted January 7, 2010 Hello Satheeshkumar, Welcome to FusionCharts Forum. Please set yAxisMinVlaue='10' and numDivLines attribute in the <chart> element to achieve this. Share this post Link to post Share on other sites
sbaskaran77 Report post Posted September 9, 2010 Hello, Is the above mentioned problem 'forceDecimals ' for yAxis is resolved in later version of fusion chart. We do have licensed fusion-chart, looking for immediate support from you folks Thanks Baskar Share this post Link to post Share on other sites
Guest Basundhara Ghosal Report post Posted September 9, 2010 Hi Baskar, Could you please send us a mail at [email protected] specifying your requirement? Awaiting your reply. Share this post Link to post Share on other sites
