elnino Report post Posted October 17, 2007 (edited) Is there any possibility to change with of bars/volume set? There is no space between sets on my chart. My XML: http://temp.elnino.pl/powercharts.xml My chart: Thanks for your help. Paul Edited October 17, 2007 by Guest Share this post Link to post Share on other sites
Pallav Report post Posted October 20, 2007 Hi, I'm afraid you cannot control the width of the bars manually. Share this post Link to post Share on other sites
elnino Report post Posted October 22, 2007 On my chart volume sets shoult be 3-4px width. Probably width is calculated by dividing chart width and amount of sets - but I have empty sets so it is wrong. Could you check it? Share this post Link to post Share on other sites
Pallav Report post Posted October 24, 2007 Hi, Can you please send us the XML for the chart at [email protected]? Share this post Link to post Share on other sites
elnino Report post Posted October 25, 2007 Pallav (10/24/2007)Hi, Can you please send us the XML for the chart at [email protected]? Link to XML file is in my first post. Thanks for help. Share this post Link to post Share on other sites
Pallav Report post Posted October 30, 2007 Since in your categories, you've specified the X as 120, the right side of the chart is appearing as blank. The x-axis in a candlestick chart is numeric and as such all x values provided in the XML are accommodated in the same. Share this post Link to post Share on other sites
elnino Report post Posted October 30, 2007 (edited) Pallav, notice that if I use "fake sets": ----- <set open="25" high="25" low="25" close="25" x="55" volume="0" /> ... <set open="25" high="25" low="25" close="25" x="120" volume="0" /> ----- set width is ok: but I can't use empty sets ( <set x="120" /> ) - they are ignored. It is very big problem - I can't show stock chart until stock session is closed. Edited October 30, 2007 by Guest Share this post Link to post Share on other sites
Pallav Report post Posted November 2, 2007 Yes - when you enter empty sets, the chart calculates width as per the known non-empty sets. As such, the width gets increased. Share this post Link to post Share on other sites
elnino Report post Posted November 2, 2007 Pallav, thans for your help, but I think that wrong calculating set width is buggy - look for my first screenshot. Is it possible to change alghoritm of calculating set width to use empty sets too? Share this post Link to post Share on other sites
elnino Report post Posted November 16, 2007 Pallav, any news in that problem? Share this post Link to post Share on other sites
