Krishna_Solanki Report post Posted November 18, 2009 Hi, I am saving the charts as images on page load. I want to set the height and width of these images at runtime. Please help. Thanks, Share this post Link to post Share on other sites
Guest Basundhara Ghosal Report post Posted November 18, 2009 Hi Krishna, If you are using the image inside the image tag then it is possible to set the width and height of the image. However if this does not work then could you you please specify the issue that you are facing a bit elaborately so that we might look into it? Awaiting your reply. :hehe: Share this post Link to post Share on other sites
Krishna_Solanki Report post Posted November 18, 2009 Hi, Thanks for the reply. When the chart save as an image , image get the same width and height of the chart. Now if i change the hesight and width of the image while displaying, its resolution get disturbed. I just wanted to know , If there is any property by which we can set the height and width of the image while saving... Thanks, Share this post Link to post Share on other sites
Guest Basundhara Ghosal Report post Posted November 18, 2009 Hi Krishna, I am afraid that as of now FusionCharts does not support the change of the width and height of the charts while exporting. ;( However, you can try it using Asp.Net where you can generate the charts at the server-side with a higher resolution and then can export it. Hope this helps. Share this post Link to post Share on other sites